User's Manual

TD 93021US Rev A
10 FEB 2014 / Ver A 71
Installation Guide
teleCARE IP
Figure 87. Inserting the screwdriver
Gently push and turn the screwdriver until the switch module releases from the spacer.
Figure 88. Removing the switch module from the backplate
Caution: Do not insert the screwdriver into the bottom corner of the faceplate.
6.4.10 Dip Switch Settings
Each room bus provides eight addresses for the connection of teleCARE IP switch modules. The lower
four of these addresses are set by a DIP switch that is located on the PCB of the certain switch module.
The upper four addresses cannot be set as they are dedicated to certain switch modules which have
the appropriate address permanently set in the switch module.