User's Manual

TD 93021US Rev A
10 FEB 2014 / Ver A 69
Installation Guide
teleCARE IP
6.4.7 Mounting the Switch Module to the Surface Mounting Spacer
To mount the switch module onto the spacer, place the lower edge of the switch module on the two
lower snap fasteners of the spacer (1). Next place the switch module on to the two top fasteners (2)
and press the switch module so that it snaps closed on the spacer.
Figure 83. Mounting the switch module on the spacer
6.4.8 Dismantling the Switch Modules
To separate the switch module from the backplate, a screwdriver with a point of approximately 0.25in
(6mm) wide should be used.
Figure 84. Suitable screwdriver for dismantling switch modules