User's Manual

TD 93021US Rev A
10 FEB 2014 / Ver A 49
Installation Guide
teleCARE IP
5.7 Corridor Lamp (NICL)
The Corridor Lamp (NICL) is controlled by the IP room controller (NIRC only) and one IP room controller
can support two corridor lamps. Each Corridor Lamp is connected to one of the three room buses of
the IP Room Controller and it always has the fixed address 5.
IMPORTANT: The room controller NIRC3 does not support the 24 volt output that is required
to power the NICL, therefore the NICL should not be used in combination with the NIRC3.
Figure 56. The teleCARE IP corridor lamp
The Corridor Lamp consists of a back box, a printed circuit module, a cover plate and translucent
dome cover that can accept up to four LED boards, as shown in the following illustration: