User's Manual

TD 93021US Rev A
10 FEB 2014 / Ver A 81
Installation Guide
teleCARE IP
6.6.5 Mounting the Medical Rail Socket
The following illustration shows how the medical rail socket is mounted in the underside of a medical
rail.
Figure 99. Medical rail socket mounting and cut-out dimensions
6.7 Door Side Module (NIDM)
The Door Side Module (NIDM) is a three-button switch module which is connected to the teleCARE IP
room bus. It has a buzzer which can be used to signal calls, a 4-pole connector for the room bus, a 4-
pole connector for a passive bus and connector for speech module.
Figure 100. Door-Side module: front and back view
6.7.1 Door Side Module Electrical Connections and DIP Switch Settings
The Door Side (NIDM) Module is an “active peripheral” therefore it must be connected to one of the
three room buses of a teleCARE IP room controller by the 4-pole room bus connector (see 6.4.1, 4-
Pole Connector Terminal on page 65).
Each room bus offers individual addresses for up to four switch modules. The address is selected using
the DIP switch on the switch module printed circuit board. The door Side module also has another 4-
pole connector for a “passive bus” which is used to connect a passive pull cord switch module and a
0.10 in.
(2.6mm)
0.10 in.
(2.6mm)
2 1/4 in.
(56mm)
2 5/8 in.
(66mm)
5/8 in.
(16mm)