User's Manual

TD 93021US Rev A
10 FEB 2014 / Ver A 70
Installation Guide
teleCARE IP
Insert the point of the screwdriver into the groove at the side of the switch module between the
faceplate and the back plate at about 0.4in (10mm) down from one of the top corners.
Figure 85. Inserting the screwdriver
Gently push and turn the screwdriver until the switch module releases from the back plate.
Figure 86. Removing the switch module from the back plate
Note: Do not insert the screwdriver into the bottom corner of the faceplate.
6.4.9 Dismantling a Switch Module from a Spacer
Insert the point of the screwdriver into the groove at the side of the switch module between the
faceplate and the spacer at about 0.40in (10mm) down from one of the top corners.