User's Manual

TD 93021US Rev A
10 FEB 2014 / Ver A 61
Installation Guide
teleCARE IP
6 Peripherals
The switch modules all have the same basic format and can be mounted as a single unit on a single
backplate or as a double unit on a double backplate.
The switch modules have one, two or three buttons with LEDs and a some switch modules have a
buzzer. The functions of the buttons and buzzer are determined by the software when system is
configured using the system manager (NISM).
6.1 Preparation
It is important to refer to the following teleCARE IP switch module installation instructions for
complete electrical connection and assembly details before starting the installation.
Ensure that the electrical power to the equipment is switched off before connecting the switch
modules.
The Ingress Protection of the switch modules is IP40, therefore it is important that the area in which
the teleCARE equipment is to be installed must be clean, dry and weatherproof.
The walls on which the switch modules are to be installed should be finished (painted, wall papered,
etc.) before the switch modules are installed.
It is important to ensure that a minimum of 14in (35cm) of free cable is pulled through at every
location where teleCARE IP switch modules are to be installed.
It is important to have the appropriate lengths of stripped cable and exposed copper wire.
6.2 Installation Instructions
This section describes the basic installation of the following devices:
• “Bedside Module (NIBM2)” on page 72
• “Medical Rail Socket (NIMS2)” on page 77
• “Door Side Module (NIDM)” (details on page 81)
• “Pull Cord Module - Active (NIPC-G3A and NIPC-W3A)” (details on page 82)
• “Toilet Cancel Module - Active (NITC-XXA)” (details on page 84)
• “Pull Cord Module - Passive (NIPC-XXP)” (details on page 85)
• “Toilet Cancel Module - Passive (NITC-XXP)” (details on page 86)
• “Pull Cord Module (NIPC2) Active and Passive” (details on page 87)
• “Duty Selector (NIDS)” (details on page 97)
• “Card Reader (NICR)” (details on page 86)
• “Speech Module (NISP)” (details on page 104)
• “Room Display (NIRD)” (details on page 106)
• “Television Interface Module” (details on page 113)
• “Sunblind Control Module” (details on page 115)