User's Manual

TD 93021US Rev A
10 FEB 2014 / Ver A 23
Installation Guide
teleCARE IP
5.2.6 Installing the Room Controller
When installing the Room Controller the first step is to separate the top section (cover, PC board and
lamp dome) from the housing. To do that simply grip the top edge of the cover and pull it away from
the housing, as shown in the following illustration:
Figure 14. Separating the top section from the housing
5.2.7 Removing the Room Controller Printed Circuit Board
To remove the circuit board from the housing, press the holding clip outwards (1) until it releases the
circuit board, as shown in the following illustration:
Figure 15. Removing the circuit board from the housing
With the printed circuit board released from the holding clip (2), partly rotate the circuit board and
remove it from the housing.