Installation and Operation Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 IP Security
- 3 Configuration
- 3.1 Requirements
- 3.2 Access the GUI
- 3.3 GUI Web Access
- 3.4 Configure the Mobility Master
- 3.5 Configure the Standby Mobility Master
- 3.6 Configure the Pari Master
- 3.7 Configure the Standby Pari Master
- 3.8 Configure the Master
- 3.9 Configure the Standby Master
- 3.10 Plug and Play Configuration
- 3.11 Configure the Radio
- 3.12 Configure Deployment
- 3.13 Add Users
- 4 Operation
- 4.1.1 Name the IPBS and IPBL
- 4.1.2 Change User Name and Password
- 4.1.3 Centralized Management of Administrator and Auditor Accounts Using Kerberos
- 4.1.4 Configure the NTP Settings
- 4.1.5 Certificates
- 4.1.6 License
- 4.2.1 Set DHCP Mode
- 4.2.2 Set a Static IP Address
- 4.2.3 Dynamic IP address via DHCP
- 4.2.4 Link
- 4.2.5 Configure VLAN
- 4.2.6 View LAN Statistics
- 4.2.7 Enable RSTP (only for IPBL)
- 4.2.8 Deactivate LAN Port (only for IPBL)
- 4.3.1 Configure IP Settings
- 4.3.2 Routing
- 4.4.1 Configure LDAP Server
- 4.4.2 Check LDAP Server Status
- 4.4.3 Configure LDAP Replicator
- 4.4.4 Check LDAP Replicator Status
- 4.4.5 Expert tool
- 4.5.1 Change System Name and Password
- 4.5.2 Set Subscription Method
- 4.5.3 Configure Authentication Code
- 4.5.4 Select Tones
- 4.5.5 Set Default Language
- 4.5.6 Set Frequency Band
- 4.5.7 Enable Carriers
- 4.5.8 Local R-Key Handling
- 4.5.9 No Transfer on Hangup
- 4.5.10 No On-Hold Display
- 4.5.11 Display Original Called
- 4.5.12 Early Encryption
- 4.5.13 Configure Coder
- 4.5.14 Secure RTP
- 4.5.15 Configure Supplementary Services
- 4.5.16 Select Mode
- 4.5.17 Set Master Id
- 4.5.18 Enable PARI Function
- 4.5.19 Set Region Code
- 4.5.20 Configure Gatekeeper
- 4.5.21 Registration for Anonymous Devices
- 4.5.22 Conferencing Unit
- 4.5.23 Select Crypto Master Mode
- 4.5.24 Select Mobility Master Mode
- 4.5.25 Connect Mobility Master to other Mobility Master(s)
- 4.5.26 Disconnect Mobility Master from other Mobility Master(s)
- 4.5.27 Connect Mobility Master to a Crypto Master
- 4.5.28 Connect Master to a Mobility Master
- 4.5.29 Enable the Radio
- 4.5.30 Enter IP Address to the PARI Master and the Standby PARI Master
- 4.5.31 Multiple Radio Configuration
- 4.5.32 PARI
- 4.5.33 SARI
- 4.5.34 Configure Air Synchronization
- 4.6.1 Add instance id to the user registration with the IP-PBX
- 4.6.2 IP-PBX supports redirection of registration when registered to alternative proxy
- 4.6.3 Use local contact port as source port for TCP and TLS connections
- 4.6.4 Session Timer (initial value)
- 4.7.1 Configure Messaging
- 4.7.2 Device Management
- 4.7.3 Service Discovery
- 4.7.4 Send Status Log
- 4.7.5 Module Fault List
- 4.8.1 Configure Automatic Firmware Update
- 4.8.2 Configure Logging
- 4.8.3 Configure the HTTP settings
- 4.8.4 Configure the HTTP Client settings
- 4.8.5 SNMP
- 4.8.6 Phonebook
- 4.8.7 Configure IP-DECT to Connect to a Presence System Using ICP
- 4.9.1 Show all Registered Users in the IP-DECT System
- 4.9.2 Search for User Information
- 4.9.3 Add a User
- 4.9.4 Add a User Administrator
- 4.9.5 Export the Users to a csv file
- 4.9.6 Show Anonymous
- 4.10.1 Radios
- 4.10.2 RFPs
- 4.10.3 Sync Ring
- 4.10.4 Sync Ports
- 4.10.5 Air Sync
- 4.10.6 Sync Lost Counter in IPBS
- 4.11.1 Air Sync Overview
- 4.11.2 Disturbances
- 4.11.3 Status
- 4.12.1 Display All Ongoing Calls in the System
- 4.12.2 Display Calls
- 4.12.3 Handover
- 4.13.1 General
- 4.13.2 Interfaces
- 4.13.3 SIP Interfaces
- 4.13.4 Gatekeeper Interfaces
- 4.13.5 Routes – Configuration
- 4.13.6 Show Active Calls
- 4.15.1 Before Upgrading
- 4.15.2 Upgrading Sequence
- 4.15.3 Software Upgrade from 2.X.X
- 4.15.4 Software Upgrade
- 4.15.5 Configuration After Updating the Firmware From Software Version 2.X.X to Later
- 4.15.6 Configuration After Updating the Firmware From Software Version 3.X.X to Later
- 4.22.1 Update Configuration
- 4.22.2 Update Firmware
- 4.22.3 Update the Boot File
- 4.22.4 Update the RFPs
- 4.27.1 Logging
- 4.27.2 Tracing
- 4.27.3 Alarms
- 4.27.4 Events
- 4.27.5 Performance
- 4.27.6 Config Show
- 4.27.7 Ping
- 4.27.8 Traceroute
- 4.27.9 Environment
- 4.27.10 RFP Scan
- 4.27.11 Service Report
- 4.28.1 Idle Reset
- 4.28.2 Immediate Reset
- 4.28.3 TFTP Mode
- 4.28.4 Boot
- 5 Commissioning
- 6 Troubleshooting
- 7 Related Documents
- Document History
- Appendix A: How to Configure and Use the Update Server
- Appendix B: Local R-Key Handling
- Appendix C: Database Maintenance
- Appendix D: Load Balancing
- Appendix E: Update Script for Configuration of Kerberos Clients
- Appendix F: Install Certificate in the Web Browser
- Appendix G: Used IP Ports
- Appendix H: Configure DHCP Options
TD 92579EN
10 April 2015 / Ver. N
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 7.2.X)
126
Signaling TCP failed (H323)
The signaling transport connection could not be
established. This usually means, the destination
(IP) is not reachable. Check network connectivity.
0x00060003 IPBS/IPBL X
Signaling timeout (H323)
A signaling timer expired. The reason for this
could be a network problem or an interop
problem.
0x00060004 IPBS/IPBL X
NAT discovery failed (SIP) 0x00070001 IPBS/IPBL X
Overload (SIP)
The SIP protocol stack reached its build-in
memory allocation limit. The total number
message allocations is limited to be safe against
denial-of-service attacks. Under normal working
conditions the limit should not be reached.
0x00070003 IPBS/IPBL X
Coder selection failed (SIP) 0x00070004 IPBS/IPBL X
Media configuration failed (SIP) 0x00070005 IPBS/IPBL X
DNS failed (SIP) 0x00070006 IPBS/IPBL X
Invalid URL (WebMedia) 0x00080001 IPBS/IPBL X
Coder missing in URL (WebMedia) 0x00080002 IPBS/IPBL X
Unexpected restart (watchdog/reset/power
on) (Cmd)
The system was restarted because of watchdog,
trap or by pressing the reset button. This event is
generated 60s after the restart.
0x000b0001 IPBS/IPBL X
Unexpected message (TLS) 0x000c010a IPBS/IPBL X
Unexpected message (TLS) 0x000c020a IPBS/IPBL X
Bad MAC (TLS) 0x000c0114 IPBS/IPBL X
Bad MAC (TLS) 0x000c0214 IPBS/IPBL X
Decryption failed (TLS) 0x000c0115 IPBS/IPBL X
Decryption failed (TLS) 0x000c0215 IPBS/IPBL X
Record overflow (TLS) 0x000c0116 IPBS/IPBL X
Record overflow (TLS) 0x000c0216 IPBS/IPBL X
Decompression failure (TLS) 0x000c011e IPBS/IPBL X
Decompression failure (TLS) 0x000c021e IPBS/IPBL X
Handshake failure (TLS) 0x000c0128 IPBS/IPBL X
Handshake failure (TLS) 0x000c0228 IPBS/IPBL X
No certificate (TLS) 0x000c0129 IPBS/IPBL X
No certificate (TLS) 0x000c0229 IPBS/IPBL X
Bad certificate (TLS) 0x000c012a IPBS/IPBL X
Bad certificate (TLS) 0x000c022a IPBS/IPBL X
Unsupported certificate (TLS) 0x000c012b IPBS/IPBL X
Unsupported certificate (TLS) 0x000c022b IPBS/IPBL X
Revoced certificate (TLS) 0x000c012c IPBS/IPBL X
Revoced certificate (TLS) 0x000c022c IPBS/IPBL X
Expired certificate (TLS) 0x000c012d IPBS/IPBL X
Expired certificate (TLS) 0x000c022d IPBS/IPBL X