Installation and Operation Manual

Table Of Contents
TD 92579EN
10 April 2015 / Ver. N
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 7.2.X)
114
4 Select "Immediate" or "Scheduled" update.
5 Select "In sequence" check box to update the selected RFPs one by one.
6 Select "When idle" check box to start the update when the RFP is idle.
7 Mark the applicable RFPs to be updated.
8 Click "Start" to upgrade the selected RFPs.
The RFP restarts after the upload is finished.
4.23 System Upgrade in System with Mobility Masters
Upgrade in the following order:
1 Upgrade all Standby Mobility Masters.
2 Upgrade all Mobility Masters.
3 Upgrade all of the remaining devices for each site by following the upgrade
sequence under
4.15.2 Upgrading Sequence on page 107.
Figure 15. System with several Mobility Masters
Note: Roaming between sites is only possible when the sites have the same software
version.
4.24 Replacing Master Hardware in Multiple Master System
If a faulty Master IPBS is replaced with a new one, then the faulty Master must have been
disconnected from the system more than 2 minutes before the new Master is connected,
otherwise all the subscription data will be lost.
For information on how to load a configuration on the new Master, see 4.22.1 Update
Configuration on page 111.
radio
master
p
ari master
radio
master
mobility
master
radio
master
p
ari master
radio
master
mobility
master
Site A Site B
Radio coverage area
r
a
d
i
o
m
aste
r
ar
i
mas
t
er
r
a
d
i
o
mas
t
e
r
m
o
bilit
y
mas
t
e
r
S
i
te
A
r
a
d
i
o
m
aste
r
p
ar
i
mas
t
er
r
a
d
i
o
mas
te
r
m
obility
maste
r
S
i
te
B