Installation guide

TD 92679GB
12 April 2011 Ver. D
Installation Guide
Elise3
34
Appendix A: Move a license from ELISE2, to Elise3
A license for a product on ELISE2 can, if the license is compatible with Elise3, be moved to
Elise3 by moving the Module key from the ELISE2 module to the Elise3 module. Example
of compatible products are UniteCM and Mobile Monitoring Gateway (MMG).
To make it easier to differ between the Module Keys, the marking “2M” is added on the
label on a Module Key from Elise3.
Note: All functions will be the same as it was in ELISE2 and only one ethernet port (LAN1)
can be used.
1 Create a backup of your configuration on the ELISE2 module.
2 Remove the four screws on the back side of the Elise3 module.
3 Slide the metal cover backwards.
4 Remove the Module Key from the ELISE2 module.
5 Replace the Module Key on the Elise3 with the one from ELISE2. See illustration
below.
6 Slide the metal cover back to the front.
7 Replace the four screws.
8 Restore the configuration.
Replacing a wall mounted ELISE2 module with an Elise3 module
The drilled holes made for the ELISE2 module are easily covered by the Elise3 module.
When mounting Elise3 on a wall be sure to follow the instructions in chapter
4.2.1 Wall
Mounting on page 10.
MODULE KEY
0123
4567
0123
4567
SD card
Elise3 circuit board