User manual

TD 92644EN
31 October 2013 / Ver. G
User Manual
Ascom d81 DECT Handset
91
LED Indications during Easy Replacement
The following table shows the LED indi
cations that are used for the handset and the charger
during the easy replacement procedure.
LED indication Description
Orange, flashing (1 000 ms on, 1 000
ms off)
File transfer during Easy Replacement.
Orange, flashing (100 ms on, 800 ms
of
f)
“Chang
e phone” indication during Easy
Replacement.
Red, flashing (100 ms on, 800 ms off) Error indication during Easy Replacement. Put back
new handset in charger.
Red, flashing (900
ms on, 100 ms off)
Error during Easy Replacement. Service needed for
both handsets.
4, 5 When the text "Please insert old phone in charger" is displayed, replace the new
handset with the old handset. The
handset can either be switched on or off.
Note: If the CR3 Charging R
ack is used, the le
ft charging slot must be used for both
handsets.
The handset is restarted and after a few seconds, the text "Savin
g settings. Do
not
remove phone from charger" appears. The charger LED changes to slow orange
flashing. It may take several minutes.
IMPORTANT: If the
old hand
set cannot communicate with the charger, put the new
handset in the charger to restore its settings (that is, the handset’s IPDI). If this step
is not performed, the new handset must be sent for service. The old handset’s
settings might be transfered to the new handset by using PDM/Device Manager. See
the handset’s Configuration Manual.
6, 7 When the text "Please insert new phone in charger" is displayed, replace th
e old
handset with the new handse
t. The text "Restoring settings" is displayed.
IMPORTANT: Do not remove the handset while the
text "Restoring sett
ings" is
displayed
8 When the text "Phone successfully replaced.
Please remove phone to restart."
appears in the display, remove the handset from the charger. The handset is
automatically restarted.