User manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Safety Instructions
- 3 Descriptions
- 4 Menu Tree
- 5 Basic Operation
- 6 Calling
- 6.1 Open the Call List
- 6.2 Incoming Call
- 6.3 Outgoing Call
- 6.4 During a Call
- 6.4.1 Adjust the Volume during a Call
- 6.4.2 Open Contacts during the Call
- 6.4.3 Turn the Microphone on/off during a Call
- 6.4.4 Lock/Unlock the Keypad during a Call
- 6.4.5 Audio Transfer
- 6.4.6 Start a New Call during Conversation
- 6.4.7 Switch between Calls
- 6.4.8 End a Call
- 6.4.9 Transfer a Call
- 6.4.10 Transfer to New Call
- 6.4.11 Conference Call
- 6.4.12 Call Back
- 6.4.13 Call Waiting
- 6.4.14 DTMF
- 6.4.15 DECT Info
- 6.5 Loudspeaking Function
- 6.6 Call Diversion
- 7 Messaging
- 8 Alarm Operation
- 9 Menu Operation
- 10 Advanced Functions
- 11 System Handling
- 12 Troubleshooting
- 13 Operation Notice
- 14 Maintenance
- 15 Related Documents
- 16 Document History
- Appendix A: Bluetooth Headset
- Appendix B: Bluetooth Barcode Reader
- Index
TD 92477GB
2009-12-08/ Ver. C
User Manual
Ascom d62 DECT Handset
70
Figure 12. Easy replaceable battery, unlock the lid and remove the battery.
14.2 Easy Replacement of Handset
Easy replacement can be used if a handset needs to be replaced due to, for example, a
broken display. The easy replacement procedure is done via the handset display and the
DC4 Advanced Desktop Charger, or the CR3 Rack Charger.
The following settings are replaced during easy replacement:
• DECT registration
• User parameters (including User ID)
• Contacts
• The extension number is assigned to the new handset.
The following settings are not replaced during the easy replacement:
• Call list
•Messages
• Bluetooth pairing list
• License(s)
1
14.2.1 Before Starting Easy Replacement Procedure
1 Check that both the old handset (that is, the handset to be replaced) and the new
handset (that is, the replacement handset) are of the same device type (d62).
Note: It is possible to perform Easy Replacement between different product licenses (that
is; Talker, Messenger, and Protector). The new handset’s procuct license is not replaced by
the old handset’s product license during the procedure
1
.
2 Check that the software of d62 is of version 2.8.19 or greater, by entering *#34# in
idle mode.
3 Check that the software of CR3 Rack Charger and/or DC4 Advanced Desktop
Charger, is of version 1.3.x or greater, by using the PDM. For more information on
how to use the PDM, see Installation and Operational Manual, Portable Device
Manager (PDM), Windows version, TD 92325GB.
4 Make sure that the handset batteries are charged before starting the easy
replacement procedure.
5 Switch off the new handset by long pressing .
1. A handset’s product license, for example d62 Messenger, and/or license dependent functions can be moved to
another handset using PDM/IMS2.