User manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Safety Instructions
- 3 Descriptions
- 4 Menu Tree
- 5 Basic Operation
- 6 Calling
- 6.1 Open the Call List
- 6.2 Incoming Call
- 6.3 Outgoing Call
- 6.4 During a Call
- 6.4.1 Adjust the Volume during a Call
- 6.4.2 Open Contacts during the Call
- 6.4.3 Turn the Microphone on/off during a Call
- 6.4.4 Lock/Unlock the Keypad during a Call
- 6.4.5 Audio Transfer
- 6.4.6 Start a New Call during Conversation
- 6.4.7 Switch between Calls
- 6.4.8 End a Call
- 6.4.9 Transfer a Call
- 6.4.10 Transfer to New Call
- 6.4.11 Conference Call
- 6.4.12 Call Back
- 6.4.13 Call Waiting
- 6.4.14 DTMF
- 6.4.15 DECT Info
- 6.5 Loudspeaking Function
- 6.6 Call Diversion
- 7 Messaging
- 8 Alarm Operation
- 9 Menu Operation
- 10 Advanced Functions
- 11 System Handling
- 12 Troubleshooting
- 13 Operation Notice
- 14 Maintenance
- 15 Related Documents
- 16 Document History
- Appendix A: Bluetooth Headset
- Appendix B: Bluetooth Barcode Reader
- Index
TD 92477GB
2009-12-08/ Ver. C
User Manual
Ascom d62 DECT Handset
50
The handset sends an absence reason code
1
to the system by establishing a call. The call
will automatically be disconnected after a few seconds.
Deactivate the Absence Setting
1 Enter “Call service” in the menu.
2 Select “Deactivate”.
3 Press "Select".
Divert Calls
The user can divert calls to another extension.
1 Select "Divert calls".
Divert Internal/External Calls
1 Select "Internal" or "External".
2 Select "Activate".
3 Enter number (maximum 24 digits) to divert to, or press the soft key to open
the phonebook.
4Press "OK".
The handset sends a diversion reason code
1
to the system by establishing a call. The call
will automatically be disconnected after a few seconds.
To stop diversion select "Deactivate" and press the confirmation button or the Soft key
"OK".
Divert Calls if No Reply
1 Select "No reply".
2 Select "Activate".
3 Enter number (maximum 24 digits) to divert to, or press the soft key to open
the phonebook.
4Press "OK"
The handset sends a diversion reason code
2
to the system by establishing a call. The call
will automatically be disconnected after a few seconds.
To stop diversion select "Deactivate" and press the confirmation button or the Soft key
"OK".
Divert Calls When Busy
1 Select "When busy".
2 Select "Activate".
3 Enter number (maximum 24 digits) to divert to, or press the soft key to open
the phonebook.
4Press "OK"
1.The code is defined when configuring the absence/diversion reason in the PDM/IMS2.
2.The code is defined when configuring the absence/diversion reason in the PDM/IMS2.