User manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Safety Instructions
- 3 Descriptions
- 4 Menu Tree
- 5 Basic Operation
- 6 Calling
- 6.1 Open the Call List
- 6.2 Incoming Call
- 6.3 Outgoing Call
- 6.4 During a Call
- 6.4.1 Adjust the Volume during a Call
- 6.4.2 Open Contacts during the Call
- 6.4.3 Turn the Microphone on/off during a Call
- 6.4.4 Lock/Unlock the Keypad during a Call
- 6.4.5 Audio Transfer
- 6.4.6 Start a New Call during Conversation
- 6.4.7 Switch between Calls
- 6.4.8 End a Call
- 6.4.9 Transfer a Call
- 6.4.10 Transfer to New Call
- 6.4.11 Conference Call
- 6.4.12 Call Back
- 6.4.13 Call Waiting
- 6.4.14 DTMF
- 6.4.15 DECT Info
- 6.5 Loudspeaking Function
- 6.6 Call Diversion
- 7 Messaging
- 8 Alarm Operation
- 9 Menu Operation
- 10 Advanced Functions
- 11 System Handling
- 12 Troubleshooting
- 13 Operation Notice
- 14 Maintenance
- 15 Related Documents
- 16 Document History
- Appendix A: Bluetooth Headset
- Appendix B: Bluetooth Barcode Reader
- Index
TD 92477GB
2009-12-08/ Ver. C
User Manual
Ascom d62 DECT Handset
44
3 Select "System"
4 Select "Subscribe"
5 Press "Next".
6 Enter System name (optional). If no system name is entered, the default name will
be used. That is System A, System B etc. depending on which system name that is
free.
7 Press "Next".
8 Enter PARK code (max. 31 digits). The PARK code may not be needed if there is no
alien DECT system within the coverage area.
9 Enter AC code. The AC code length must be between 4 - 8 digits.
10 Press "Next".
11 An information text "Protection on?" is displayed. Select "Yes" if the new system is
to be protected. It is not possible to delete a protected subscription from the System
meny
1
.
12 Press "OK". A searching mode starts.
Unsubscribe System
1 Enter the menu by pressing the “Menu” soft key.
2 Select in the menu.
3 Select "System".
4 Select "Unsubscribe"
1
.
5 Select the system to unsubscribe.
6 Press "Yes to unsubscribe the system.
Rename System
It is possible to change the name of the system in the handset.
1 Select "Rename System".
2 Select system to rename.
3 Enter new name.
4 Select "Save".
Priority
The default order of priority is the order of entered subscriptions. This means that the first
subscribed system has the highest priority. This list can be edited by the user. It is possible
to set the systems in priority by moving them up or down in the list.
Note: This is used in combination with system set to be "Automatic", see Change System
on page 43.
1 Select "Priority".
2 Change the priority if needed by selecting "Up" or "Down". The priority will be
saved when "Back" is selected.
1.It is not possible to unsubscribe a protected system via the System menu. The unsubscribtion must be made via the
Admin menu or the DECT system.