Operation Manual

TD 92477EN
15 June 2012 / Ver. G
User Manual
Ascom d62 DECT Handset
81
LED Indications during Easy Replacement
The following table shows the LED indications that are used for the d62 and the charger
during the easy replacement procedure.
See also 14 Troubleshooting on page 73.
4, 5 When the text "Please insert old phone in charger" is displayed, replace the new
handset with the old handset. The handset can either be switched on or off.
Note: If the CR3 Rack Charger is used, the left charging slot has to be used for both
handsets.
The handset will be restarted and after a few seconds, the text "Saving settings. Do
not remove phone from charger" appears. The charger LED changes to slow orange
flashing. It may take several minutes.
IMPORTANT: If the old handset cannot communicate with the charger, put the new
handset in the charger to restore its settings (that is, the handset’s IPDI). If this step
is not performed, the new handset must be sent for service. The old handset’s
settings might be transferred to the new handset by using PDM. See the handset’s
Configuration Manual.
6, 7 When the text "Please insert new phone in charger" is displayed, replace the old
handset with the new handset. The text "Restoring settings" is displayed.
IMPORTANT: Do not remove the handset while the text "Restoring settings" is
displayed.
8 When the text "Phone successfully replaced. Please remove phone to restart."
appears in the display, remove the handset from the charger. The handset is
automatically restarted.
LED indication Description
Orange, flashing (1 000 ms on, 1 000
ms off)
File transfer during Easy Replacement.
Orange, flashing (100 ms on, 800 ms
off)
“Change phone” indication during Easy
Replacement.
Red, flashing (100 ms on, 800 ms off) Error indication during Easy Replacement. Put back
old handset in charger.
Red, flashing (900 ms on, 100 ms off) Error during Easy Replacement. Service needed for
both handsets.