Operation Manual

TD 92477EN

15 June 2012 / Ver. G

User Manual

Ascom d62 DECT Handset

16.2.2 Easy Replacement Procedure

During the Easy Replacement procedure, the LEDs of the handset and the charger follow the

same LED indications. This means that if the old handset has a broken display, the LED

indications on the charger and on the handset can be used to follow the replacement

procedure. Before and after easy replacement, the LEDs may have different LED indications.

For more details, see LED Indications during Easy Replacement on page 81.

IMPORTANT: Never remove a handset from the charger until the instructions in the display

or the LED tells you to do so (see status on the LED if the display is broken). If there is an

error indication it may be allowed to remove the handset, see 14 Troubleshooting on page

73 for further instructions.

After the old handset has been in the charger, the new handset needs to be placed in the

charger regardless if the replacement was successful or not. Failing to do so may result in

malfunction and the new handset will need to be sent for service.

Figure 15. Easy Replacement via DC4 Advanced Desktop Charger.

1 On the new handset, press and hold

Note: Do not release until you are instructed to do so.

2 Put the new handset in the charger.

3 When the text "Start phone replacement?" is displayed, release .

Press "Yes" (left soft key).

The text "Follow the instructions. Each step can take several minutes." appears in the

display. Press "OK"(left soft key).

New New Old

New

4, 8 5 67