Operation Manual

TD 92477EN

15 June 2012 / Ver. G

User Manual

Ascom d62 DECT Handset

Change System

Select “Automatic” or a specific system. If the handset is set to “Automatic” it selects a

system according to the priority list, see Priority on page 47.

Subscribe IP-DECT System (Release 4.0 and higher)

A handset can subscribe to an IP-DECT system automatically if the following are fulfiled:

• The IP-DECT system is configured for Easy Registration, see the corresponding

Installation and Operation manual for the IP-DECT system.

• The handset’s IPEI is registered in the IP-DECT system, see the corresponding Installation

and Operation manual for the IP-DECT system.

• The handset is not subscribed to any systems.

• The handset software is 3.2.x or greater.

1 If needed, switch off the handset by pressing .

2 Switch on the handset by pressing .

3 Select language to be used or press "Cancel". If Cancel is pressed, the default

language (English) will be used.

4 The handset starts to search for IP-DECT systems and will subscribe to the system

when it is found.

Note: If no system is found within 2 minutes, the handset’s subscription menu is

displayed, see Subscribe Other System for more information.

Subscribe Other System

If a handset shall subscribe to other systems such as IP-DECT (release 3 or older), or DECT,

the system must be subscribed manually. If the handset shall subscribe additional system, it

must also be added manually.

To subscribe a new system, the “Park:” (Portable Access Right Key) and “Ac:”

(Authentication code) related to the system are needed. Contact the system administrator

for more information.

Note: The PARK code may not be needed if there is no alien DECT system within the

coverage area.

The IPDI code is a unique code which has been assigned to the handset, see also 12.1 Admin

Menu on page 71.

1 Enter the menu by pressing the “Menu” soft key.

2 Select in the menu.

3 Select "System".

4 Select "Subscribe".

5 Press "Next".

6 Enter System name (optional). If no system name is entered, the default name will be

used. That is System A, System B etc. depending on which system name that is free.

7 Press "Next".

8 Enter PARK code (max. 31 digits). The PARK code may not be needed if there is no

alien DECT system within the coverage area.

9 Enter AC code. The AC code length must be between 4 - 8 digits.

10 Press "Next".