Operation Manual

TD 92477EN
15 June 2012 / Ver. G
User Manual
Ascom d62 DECT Handset
36
7.3.6 Call a Number Included in a Message
If the sender has written a number in the message it is possible to call the number without
dialling it.
1 Select "View".
2 Do one of the following:
• Press "More" and select "Call no. in text"
1
.
• Press .
3 If the message contains several numbers, select the number to be called from the list.
4 Press "Call", or .
7.3.7 Save Number
1 Enter “Messaging” in the menu, see 4.4 Messaging on page 20.
2 Select "Inbox".
3 Select message .
4 Select "View".
5 Press "More".
6 Select "Save number".
7 Select "Work number", "Mobile number", or "Other number".
8 Add name and press "OK".
9 Press "Save". The number will be saved in the contact list.
7.3.8 Write and Send a Message
1 Enter “Messaging” menu, see 4.4 Messaging on page 20.
2 Select “Write new message”.
3 Write the message. Keys 0-9, * or # can be used. Key 0 and 1 contains special
characters, see 3.5 Alphanumeric Keys on page 16 to see all characters.
The maximum message length is 160 characters.
NOTE: Some characters require 2 bytes in the final message, therefore the user will
sometimes not be able to enter 160 characters.
The first character entered will be an upper level character followed by lower level characters
unless the * -key is pressed before entering the character.
When pressing a key, the first available character on that specific key is displayed, see 3.5
Alphanumeric Keys on page 16. To get any of the other characters on that key, press the key
until that character appears in the display.
Example: to get the character E, press key 3 twice. "E" appears in the display and is selected
after a timeout or when another key is pressed.
To delete a character, press "Clear".
4 Press "Send".
5 Enter the call number.
6 Press "Send" to send the message.
1.Visible if the number consists of minimum 3 digits.