Operation Manual

TD 92477EN

15 June 2012 / Ver. G

User Manual

Ascom d62 DECT Handset

6.4.15 DTMF

Some systems/PBXs require that the handset sends Dual Tone Multi Frequency (DTMF)

when pressing the keys. DTMF can be enabled as follows:

1 Press the soft key "More" during the call.

2 Select "DTMF"

3 Press "Select". This will enable the use of DTMF signals.

TIP: It is also possible configure the handset to send DTMF when pressing and pressing

releasing . See the handset’s Configuration Manual. This is not applicable for d62

Talker.

6.4.16 DECT Info

This option is only visible if the Admin menu is activated. See Configuration Manual, Ascom

d62 DECT Handset, TD92639GB for more information.

6.5 Loudspeaking Function

There are five options to activate the loudspeaking function:

• Press a Multifunction button

, Navigation key, Hot key or Soft key defined as short cut to

a "Phone call

" function. When pressing the key/button, a predefined number is called, see

9.3 Short Cuts on page 55.

• When receiving a call, press the left soft key

• During a call, press the left soft key

• During a call, put the handset in a charger. Requires that Loudspeaking is chosen in the In

Charger menu.

• This function can also be activated by selecting another answering method, that is,

"Automatically" and/or "Loudspeaking". See 9.8.5 Answering on page 67.

6.6 Call Diversion

All calls; internal calls, external calls, calls when busy, or calls at no answer can be diverted to

another handset number. The diversion is made via the Calls menu > Call services > Divert

calls. See Divert Calls on page 54.

In addition, an absence reason (for example “Lunch”, “Meeting”, “Trip” etc.) can also be set.

The absence reason is set via the Calls menu > Call services > Absence. See 9.2.9 Call

Services on page 53 .

NOTE: PBX settings for the call diversion must be set in order to show the Divert calls menu

in the handset. See the handset’s Configuration Manual.

NOTE: If both diversion and absence reason are set, the absence reason will be used.

Either can a Soft key, Hot key, or Multifunction

button be preprogrammed with a short cut

to the diversion function or the absence reason/menu. See 9.3 Short Cuts on page 55.

1.The Multifunction button is applicable for d62 Talker and d62 Messenger only.

2.The left Soft key might have another/no function depending on its configuration of the In call function in PDM/IMS3