User's Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Description
- 3 Safety Instructions
- 4 Basic Operation
- 5 Alarm Functions
- 6 Messaging
- 7 Navigate the Menu
- 8 Menu Tree
- 9 Menu Operations
- 9.1 Messages
- 9.2 Profiles
- 9.3 Services
- 9.4 Settings
- 9.4.1 Change the Volume
- 9.4.2 Increasing Volume On/Off
- 9.4.3 Vibrator On/Off
- 9.4.4 Message Reminder On/Off
- 9.4.5 Key Beep On/Off
- 9.4.6 Deactivate/Activate Man-down alarm
- 9.4.7 Deactivate/Activate No-movement alarm
- 9.4.8 Deactivate/Activate Pull-cord alarm
- 9.4.9 Set Alarm Data
- 9.4.10 Change the Message Text Size
- 9.4.11 Backlight On/Off
- 9.4.12 Change the Contrast
- 9.4.13 Turn Automatic Key Lock On/Off
- 9.4.14 View Shortcut Keys
- 9.4.15 Select Language
- 9.4.16 Group Numbers
- 9.4.17 Show Time and Date
- 9.4.18 Set Time Format
- 9.4.19 Set Date Format
- 9.4.20 Display System Information
- 9.5 System Test
- 10 Operation Notice
- 11 Maintenance
- 12 Related Documents
- Appendix A: Programming the Transceiver
PRELIMINARY
TD 92417GB
2007-02-19/ Ver. PA
User Manual
Ascom a71 Alarm Tranceiver and Ascom p71 Transceiver
8
4 Basic Operation
Note: The transceiver may have functions other than described, depending on the pre-
programmed parameters.
4.1 Switch the Transceiver On/Off
To switch the transceiver On:
1 Press and hold
OK
.
2Press "Yes" soft key.
To switch the transceiver Off:
1 Press and hold .
2Press "Yes" soft key.
4.2 Mute the Transceiver
1 Press and hold the “Mute” button. is shown in the display.
4.3 Lock the Keys Manually
1 In stand-by mode, shortly press
C
.
2 Press "Yes" soft key.
To unlock the keypad:
1Shortly press
C
.
2 Press "Yes" soft key.
4.4 Charge the Battery
Charging is done in a single charger or a wall mounted charging rack. It is recommended
that the transceiver is charged daily.
Note: Charge the battery for at least two hours before it is used the first time.
A flashing orange LED indicates charging. A green steady LED and a filled icon shows
a fully charged battery. It takes approximately two hours to charge the battery. An empty
battery icon in the display and a beep signal played once every minute together with a fast
flashing red LED indicates an empty battery.
To replace the battery, see 11.2 Replace the Battery on page 25.
Note: While charging, Man-down & No-movement alarms are automatically deactivated.
The Location Function (IR and LF) is also deactivated. (If a push-button alarm is sent, the
last stored location before charging the transceiver, is sent).
Note: If the transceiver is put into the charger during the shutdown warning beep, the
beep will stop and the portable is charged.