User manual

Release 2.2 Digium, Inc. Page 45
Chapter 3: Configuration
Testing Your Configuration.
1. Load Zaptel drivers into the kernel using the program modprobe. The
appropriate driver for the TE120 Series cards is
wcte12xp. Use the
following modprobe command:
# modprobe wcte12xp
# ztcfg -vv
# dmesg
Figure 8: Example dmesg Output
2. Run zttool from the command line and see if the span turns green for
each span you have connected.
zttool
ACPI: PCI interrupt 0000:01:00.0[A] -> GSI 21 (level, low) -> IRQ
209
PCI Config reg is 02900117
wcte120p: New Reg: fe590000!
Detected REG0: 00000100
Detected REG1: 00007849
Detected REG2: 0000001d
(pre) Reg fc is 50000027
Detected REG0: 0000ffff
(post) Reg fc is 50000024
Detected REG2: 0000ffff
wcte120p: reg is a04c0004
TE120P: FALC version: 00000000
TE120P: Setting up global serial parameters for T1 FALC V1.2
TE120P: Successfully initialized serial bus for card
Found a Wildcard TE: Wildcard TE120P