User manual

Release 2.2 Digium, Inc. Page 30
Chapter 2: Card Installation
1. Check your lspci PCI device listing. Boot the computer into Linux.
After the machine has loaded, log in and execute the following:
# lspci -n | grep d161
Confirm your lspci PCI device listing by scanning for the following
information in the output screen:
0000:01:00.0 0200: d161:<card identifier>
In the device listing shown above, <card identifier> will be populated
with one of the identifiers listed in the table below.
Table 1: Card Identifiers
A Digium TE120 Series (TE120P/TE121/TE122) ISDN Controller
should be identified. If a controller is not identified, then your machine
is not PCI 2.2 (or higher) or PCI Express compatible and the card will
not work with your equipment. Please contact Digium’s technical
support for assistance.
Model Identifier
TE120P
TE121
TE122
0120
8000
8001