User manual

Release 2.2 Digium, Inc. Page 29
Chapter 2: Card Installation
Software Installation
The TE120 Series cards are only supported on a Linux system. Digium,
Inc. recommends Debian, Fedora, and Red Hat. Digium hardware
requires drivers and libraries that are integrated with the Linux kernel.
You can obtain the source code from downloads.digium.com
. Detailed
instructions are provided in this section.
To install software for your TE120 Series card, you will need:
 Full Linux kernel 2.6 (or later) source code
 Development libraries and headers for libncurses (only necessary for
Asterisk 1.2; or for Zaptel 1.4 and Asterisk 1.4).
 Development libraries and headers for zlib and openssl.
 If you are using the 1.2.x series of Asterisk and Zaptel, you will need
Asterisk 1.2.26 or newer, and Zaptel 1.2.23 or newer. If you are using
the 1.4.x series of Asterisk and Zaptel, you will need Asterisk 1.4.17
or newer and Zaptel 1.4.8 or newer.
Caution.
This unit must be connected to the Telecommunications
Network in your country using an approved line cord.
Caution.
This unit must be connected only to the appropriate
Telecommunications Network port (as approved for use in your
specific country).