Product manual

Upgrade from DCT1800-A to DCT1800-GAP R1B – January 1999
Technical Product Manual - DCT1800-GAP
TD 92093 (1/LZBNB 103 108 R4D) / 2006-03-09/ Ver.C
© 2006
1
Chapter 1 Upgrade from DCT1800-A to DCT1800-GAP R1B –
January 1999
1.1 Introduction
This chapter describes how systems with the A-protocol can be updated to the GAP-protocol. Systems
with the B-protocol (mobility) cannot be updated.
When updating a DCT1800-A system to a DCT1800-GAP R1B system all except the following system
components can be reused:
• Central cabinet BFLNB 101 05/n and related products such as cables and power supply.
• Cordless phone DPANB 201 0x/3
• CPU board 2/ROFNB 157 06
• CPU firmware RYT/ROFNB 157 06/2
• SPU board ROFNB 157 08/n
• DTU-E1 CAS firmware set NTM/RYSNB 101 17/1
• DTU CAS firmware RYT/ROFNB 157 03/2
• Cordless system manager software LZYNB 201 01
• Cordless system statistics software LZYNB 201 02
The CPU board has to be replaced by a new one. Cordless phones of the type DPANB 201 0x/3 are
to be replaced by GAP cordless phones. All other cordless phones and base stations can be updated
by downloading new software.
Table 1 shows the firmware that must be updated to indicated minimum revisions. Cordless system
manager LZYNB 201 05/n and cordless system statistics LZYNB 201 06/n must be updated to revision
R2B.
Systems using a CCS interface cannot be updated. The DCT1800-GAP system only supports LTU,
CAS and CAS+ interfaces.
Table 2 gives an overview of all items required for upgrading. To upgrade a system, it has to be taken
out of service.
Board Product code board Product code firmware Minimum revision
CLU ROFNB 157 11 or
ROFNB 157 11/2
NTM/RYSNB 101 44/2 R2A
CLU-S ROFNB 157 16/2 NTM/RYSNB 101 19 R2A
SLU ROFNB 157 16/1 NTM/RYSNB 101 19
NTM/RYSNB 101 20
R2A
R2A
SPU-S ROFNB 157 16/3 NTM/RYSNB 101 20 R2A
DTU 2/ROFNB 157 03 RYT/ROFNB 157 03/5 R1C
DTU-E1 2/ROFNB 157 13/6 NTM/RYSNB 101 17/10 R1C
Table 1 Minimum revision of firmware