Product manual

Installation instructions, Cables
Technical Product Manual - DCT1800-GAP
TD 92093 (1/LZBNB 103 108 R4D) / 2006-03-09/ Ver.C
© 2006
169
Fig. 121 CLU/MDF cable set, long – REX-CAB9006 (NTM/TSRNB 101 46) (cont’d)
25.22 DTU twisted pair cable set – REX-CAB9007 (NTM/TSRNB 101 49)
The DTU twisted pair cable set (see figure 122 and 123) consists of two shielded cables
(TSRNB 101 49/1 and TSRNB 101 49/2). The cables are used to connect a DTU (2/ROFNB 157 13/1)
to a PBX directly or via an MDF. The shielding of the cables is connected to the cabinet via a clamp
which also functions as a pull relief. The only difference between the two cables is the location on the
cable where the clamp is attached to the shielding. This is respectively 325 mm from the connector
for cable TSRNB
101 49/1 and 445 mm for cable TSRNB 101 49/2. The length of the cable is 15 m.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
K1
25 m 10 cm
K1
325 or 445 mm
50
mm
±
102