Product manual

Installation instructions, Cables
Technical Product Manual - DCT1800-GAP
TD 92093 (1/LZBNB 103 108 R4D) / 2006-03-09/ Ver.C
© 2006
167
25.20 LTU/MDF cascade cable set, long – REX-CAB9005 (NTM/TSRNB 101 45)
The LTU cascade cable set long (see figure 119) is used for the connection of the LTU, which supports
cascade connections, to an MDF. Both cables are shielded cables with a connector at one side. The
shield of the cable is connected to the modular cabinet by a clamp. This clamp also functions as pull-
relief. The only difference between the two cables is the location on the cable where the clamp is
attached to the shielding. The clamp is placed at respectively 325 mm from the connector for the
TSRNB 101 45/1, and 445 mm for the TSRNB 101 45/2. The length of the cable is 25 m.
Fig. 119 LTU/MDF cascade cable set, long – REX-CAB9005 (NTM/TSRNB 101 45)
1
2
3
4
5
6
7
8
K1
1
2
3
4
5
6
7
8
common
braided shield
A
B
shield only connected to cabinet !
a'0
b'0blue
white a0
b0
orange
white
green
a'1
b'1
white
brown
a1
b1
white
white
grey
a'2
b'2
red
blue
a2
b2
red
orange
red
a'3
b'3
green
a3
b3
notch >
AB
25 m 10 cm
K1
325 or 445 mm 50 mm
±
100