Product manual

Installation instructions, Installation instructions BS370 Wireless Relay Station
Technical Product Manual - DCT1800-GAP
TD 92093 (1/LZBNB 103 108 R4D) / 2006-03-09/ Ver.C
© 2006
90
The BS370 can automatically give itself a base station number. It detects which numbers the
surrounding base stations have and gives itself a free base station number. However, there may
be a base station that the BS370 cannot see, having this base station number already. In that
case, two base station numbers may have the same number. These base stations cannot be used
to set up a call.
• If you want to automatically give the WRS a base station number, use ‘Dynamic identity
allocation’.
• If you want to give the WRS a base station identity yourself: enter the base station number for
the WRS. Recommended numbers for the WRS are from 80 up to FF (hex.).
13. Lock the WRS to a system and/or host base station. Use the appropriate ‘Locking method’ and
enter the required input:
14. Select Base Station - Disconnect.
15. Disconnect the RS232 cable from the BS370.
16. For ease of installation you can disconnect the power connector from the BS370. If used, you
can also disconnect the connector of the external antenna.
18.5.6 Fixing the mounting bracket to a wall
Fix the mounting bracket (see figure 56) to the wall as follows:
1. Hold the mounting bracket with its flat side against the wall such that the text ‘TOP’ is up, and
mark the two holes. The minimum distance between the upper hole and the ceiling or any object
‘Locking method’ When to be used Function Required input
‘Lock to strongest system’ There is only one DECT
system present and plan
-
ning of base station traffic is
not important.
The BS370 searches for a
DECT system and host
base station itself. The
BS370 automatically locks
to this DECT system and
host base station.
-
‘Lock to system’. You want to specify the
DECT system because
there are more DECT sys
-
tems present, but planning
of base station traffic is not
important.
The BS370 will automati-
cally lock to a host base
station on the specified
DECT system.
• Indicate which system is
used: MD110 or
DCT1800/Business
-
Phone.
• Fill in the ‘P-ARI (B-ARI)’
number (the DECT sys
-
tem number).
‘Lock to specific base sta-
tion on system’.
Planning of base station
traffic is important and you
want to specify both the
host base station and the
DECT system
The BS370 will lock to the
specified host base station
on the specified DECT sys
-
tem.
• Indicate which system is
used: MD110 or
DCT1800/Business
-
Phone.
• Fill in the ‘P-ARI (B-ARI)’
number (the DECT sys
-
tem number).
• Fill in the ‘Host base sta-
tion identity’: the base
station number of the
host base station.
Table 3 Locking methods