Product manual

Installation instructions, Installation instructions BS370 Wireless Relay Station

Technical Product Manual - DCT1800-GAP

TD 92093 (1/LZBNB 103 108 R4D) / 2006-03-09/ Ver.C

• Two 8-pin RJ45 modular jacks for powering.

The two powering connectors are interconnected on the board.

• A 6-pin RJ12 modular jack for service and configuration.

18.2.4 Powering by local adapter

A 24 Vdc adapter (BMLNB 101 09/n) can be used to power the BS370. This adapter is provided with

an 8-pin RJ45 plug that can be plugged into one of the power connectors of the BS370. It makes no

difference which power connector is used.

Note:

Only approved power supply according to valid editions of EN/IEC/CSA/UL/AU/NZS 60950 is to be

used when the base station is powered by a local power supply.

The pinning of the RJ45 power connector is as follows:

Fig. 46 Pinning power connector (connector seen from cable input side)

18.2.5 Base Station Manager software

For the BS370 a special software tool is available: the Base Station Manager (NTM/CXCNB 110

01/1D). You need the Base Station Manager to:

• Configure the BS370

• Download software to the BS370 (in flash memory)

• Read out logging data, to facilitate troubleshooting

You can connect a PC with the Base Station Manager software to the BS370 using the RS232 cable

with level shifter. This cable is delivered as part of the Base Station Manager package.

Tip:

You can also use the Base Station Manager to download software to BS330 and BS340 or read out

logging data of these base stations.

Note:

When configuring the BS370 with the Base Station Manager, the BS370 will not continuously be

operational.

Power

Not used

112