Product manual

Installation instructions, Modular cabinet – REX-BAS900nn (BDVNB 101 01/16)
Technical Product Manual - DCT1800-GAP
TD 92093 (1/LZBNB 103 108 R4D) / 2006-03-09/ Ver.C
© 2006
14
4.5 Pre-mounting of a modular cabinet in a one cabinet system
1. Remove the cover of the cabinet (see figure 6):
– loosen the screws that secure the cover (1),
– lift the front cover approximately 10 mm (2),
– remove the cover by lifting the lower edge towards you (3).
2. Remove the drawer to ease installation:
– open the drawer by pulling it toward you (4),
– release the drawer by pulling the lower side of the modular cabinet as indicated in figure 6 (5)
and remove the drawer (6).
3. Loosen the screw of the securing bar at the front of the modular cabinet then remove the securing
bar.
4. Mount the mounting bracket to the wall, such that the bottom side of the modular cabinet is about
1.60 m above the ground, using the enclosed wood screws and plugs.
5. Hang up the cabinet and mark the lower two retaining holes.
6. Drill the holes and insert the plugs.
The easiest way to install the modular cabinet’s cabling, is to put the cabinet on its back on a desk.
4.6 Pre-mounting of modular cabinets in a multi cabinet system
When a system consists of more modular cabinets, the modular cabinets have to be interconnected
using an interconnection set for the modular cabinet. In this paragraph only the shielding gasket of
the interconnection set is used. The use of the other items of the interconnection set is described in
paragraph
4.8.
1. Remove the cover of the cabinet (see figure 6):
– loosen the screws that secure the cover (1),
– lift the front cover approximately 10 mm (2),
– remove the cover by lifting the lower edge towards you (3).
2. Remove the drawer to ease installation:
– open the drawer by pulling it toward you (4),
– release the drawer by puling the lower side of the modular cabinet as indicated in figure 6 (5)
and remove the drawer (6).
3. Loosen the screw of the securing bar at the front of the modular cabinet and remove the securing
bar.
4. Remove the conductive tape or brake-out plates in the side panels that are going to be positioned
next to the other cabinet’s side panels.
5. Place the shielding gaskets as indicated in figure 8.
6. Mount the mounting bracket to the wall, such that the bottom side of the modular cabinet is about
1.60 m above the ground, using the enclosed wood screws and plugs. For modular cabinets with
revision R2 the distance adjustment plate can be used (see figure
7).