Product manual

Installation instructions, Installation steps
Technical Product Manual - DCT1800-GAP
TD 92093 (1/LZBNB 103 108 R4D) / 2006-03-09/ Ver.C
© 2006
9
3.7.1 Board position labels
The board position labels can be stuck to the bar below the system board as indicated in figure 2. The
labels must be stuck before installing the cabling.
Fig. 2 Position of the board position labels
3.7.2 Cabinet number labels, board name labels and cable position labels
Label each item with the corresponding label after installation is completed. Especially labelling of the
cables is important to avoid re-connection of cables to the wrong place after maintenance has been
carried out.
The cable position labels indicate the board position and the position of the connector the plug is
connected to. Figure
3 gives the standard connector positions on all board (position 1 – 4) and two
examples of the labelling. If more than one position is used by the plug, mark the plug with the lower
position used.
28 32 36 40 44 48 52 5624
Board position label
002