Product manual

Installation instructions, General
Technical Product Manual - DCT1800-GAP
TD 92093 (1/LZBNB 103 108 R4D) / 2006-03-09/ Ver.C
© 2006
3
Chapter 2 General
2.1 Environmental requirements
The building (rooms) in which the radio exchange and base stations are to be installed must comply
with the following:
• The air shall be free from dust and smoke. It shall not contain gases or acid fumes that can affect
the condition of metal parts or insulation materials.
• Relative humidity may vary between 20 - 90%. The temperature may vary between 0 °C and
+40
°C for the radio exchange. The temperature may vary between −10 °C and +55 °C for the
base stations.
• The equipment must not be exposed to direct sunlight due to the risk of heat generation.
• Every effort should be made to place the base stations and especially the radio exchange in a
‘quiet’ EMI environment.
2.2 Safety and regulatory information
Before starting any installation, read section 1 ‘Safety and regulatory information’ in this manual. This
section contains important safety instructions and country dependent information.
2.3 ESD socket
The cabinets are equipped with a banana plug socket to connect an anti-static wrist strap. When the
front cover has been removed, you can find this socket on the right lower edge of the modular cabinet.
2.4 Installation tools
The following installation tools are required:
• ESD wrist strap
•Multimeter
• Torx screwdrivers (8,10, 20, 25 and 30)
• Screwdriver (3 and 12 mm)
• Wrench 8 to connect the batteries in the battery power unit
• Knife to strip cables
• Stripping plier
• Telephone plier (long nose)
Caution
Read and follow the handling instructions described in section ’Safety and regulatory information’ chapter
’Protection against electrostatic discharge (ESD)’.
Boards which contain Electrostatic Sensitive Devices (ESD) are indicated by the sign shown on the left.
If the instructions are not followed, there is risk of damage to the equipment.