Product manual

Product specifications, Introduction
Technical Product Manual - DCT1800-GAP
TD 92093 (1/LZBNB 103 108 R4D) / 2006-03-09/ Ver.C
© 2006
1
Chapter 1 Introduction
This section lists the safety standards which are met by the DCT1800-GAP system. It also contains
a detailed list of technical specifications of the DCT1800-GAP products.
Chapter 1 : ‘Introduction‘ on page 1
Introduces you to this document
Chapter 2 : ‘System‘ on page 3
Lists the characteristics of the DECT air interface and the DCT1800-GAP system.
Chapter 3 : ‘Base stations‘ on page 5
Lists the regulations, standards and environmental conditions applicable for the
base stations. Physical and electrical characteristics are also listed.
Chapter 4 : ‘Modular cabinet – REX-BAS900n (BDVNB 101 01/16)‘ on page 9
Lists the compliance to regulations and standards, environmental, physical
specifications, electrical characteristics of the modular cabinet backplane and the
modular cabinet connection board.
Chapter 5 : ‘System boards‘ on page 11
Lists the compliance to regulations and standards, environmental, physical
specifications and electrical characteristics.
Chapter 6 : ‘Firmware (on EPROM)‘ on page 17
Lists the orderable DTU and CPU firmware.
Chapter 7 : ‘Power supply units‘ on page 19
Lists the compliance to regulations and standards, environmental, physical and
electrical characteristics.
Chapter 8 : ‘Cables‘ on page 23
Lists the physical characteristics.
Chapter 9 : ‘Software‘ on page 25
Lists the minimum PC requirements to run the software tools.