Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
92
2 Click “Activate”.
9.1.3 TAP Protocol in
1 The following settings can be selected/changed:
Mode: Select mode.
Default: 8 Data bits, Even parity
Flow control: Used for handshaking control. Default: None
Default Call ID: Number to call if not specified in the external
equipment. Default: 000
IP Address of Event Handler: A paging received via this serial interface will
override the number plan and be sent directly to the
Event Handler specified here.
Default display message: Message to display if not specified in the external
equipment. Default: BLANK
Default message priority: Priority if not specified in the external equipment.
Default: 7 (Normal)
Default beep code: Beep code if not specified in the external equipment.
Default: 2 beeps
Transmission delay (x10 ms): How long to wait before transmission to external
equipment. Default: 30 milliseconds
Status to ext equipment: If status characters ACK/NAK shall be sent on
protocol level to external equipment.
Default: Yes
Start character : Start character for the message.
Default: < (3C Hex)
End character: End character for the message.
Default: > (3E Hex)
Record separator character: Record separator character for the message.
Default: / (2F Hex)
ACK character: Character for positive acknowledge of the message
on protocol level. Default: A (41 Hex)
NAK character: Character for negative acknowledge of the message
on protocol level. Default: N (4E Hex)
ASCII conversion table: Makes it possible to convert display message
characters.
Settings Description
Enabled: Yes/No selection. Default: No
Name: Description of the channel
Serial port: Port selection (1,2)
Default: None
Port 2 will be selected when set from the Wizard,
but both ports can be configured here. Note that
only one port at the time can be used.
Bit rate: Select bit rate.
Default: 9600 bits/s