Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
91
2 Click “Activate”.
9.1.2 Ascom Line Protocol
1 The following settings can be selected/changed:
Timeout mode TTL (seconds): Determines the time for timeout mode i.e. during
this time the paging remains in the queue after the
“Timeout mode“ has started. Default: 5 seconds.
Manual Ack type: Dependent on if the external equipment supports
negative acknowledge. Default: Positive and
Negative manual acknowledge.
Manual Ack TTL (minutes): How long a paging with manual acknowledge
remains in the queue after transmission of Call
Terminated call status. Default: 5 minutes.
Message Ref. ID TTL (minutes): How long a Message Reference ID remains in queue.
Only valid for Ascom dialect.
Default: 5 minutes.
Interactive Message Option Text
for Callback number:
Note: For this setting to have
effect, Interactive messaging
(IM) must be supported by the
handset.
Defines text that will be added to call digits sent
from external equipment. The text and the number
to call, is received as an option in the receiving
handset. The call digits are dialled when the user
selects the option.
Max 40 characters.
Note: Overrides Message Ref. ID TTL. Leave empty if
data identifier 9 is used for message reference.
Return Status Information: Defines if status information for ongoing pagings
shall be sent back to external equipment.
Set to “No“ if external equipment have problems
handling status information.
Default: Yes.
Supervision time for
communication (seconds): Defines the time before lost communication with
external equipment will be considered as a fault and
sent as a Status log. If set to “0“ no supervision is
done.
Max 3600 seconds
Default: 0
ASCII conversion table: Makes it possible to convert display message
characters.
Settings Description
Enabled: Yes/No selection. Default: No
Name: Description of the channel
Serial port: Port selection (1,2)
Default: None
Port 2 will be selected when set from the Wizard,
but both ports can be configured here. Note that
only one port at the time can be used.
Bit rate: Select bit rate.
Default: 9600 bits/s