Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
90
9.1.1 ESPA Protocol In
1 The following settings can be selected/changed:
Settings Description
Enabled: Yes/No selection. Default: No
Name: Description of the channel
Serial port: Port selection (1,2)
Default: None
Port 2 will be selected when set from the Wizard,
but both ports can be configured here. Note that
only one port at the time can be used.
Bit rate: Select bit rate. Default: 9600 bits/s.
Mode: Select mode. Default: 8 Data bits, Even parity
Flow control: Used for handshaking control. Default: None
ESPA dialect: Select dialect, with or without an extra Carriage
Return (CR).
Default: TeleCourier extensions (i.e. Ascom dialect)
Control station selection: Determines which module shall act as control
station. Default: External equipment.
Address of external equipment: Enter address (0 - 9). Default: 1
Address of this module: Enter address (0 - 9). Default: 2
Default Call ID: Number to call if not specified in the external
equipment. Default: 000
IP Address of Event Handler: A paging received via this serial interface will
override the number plan and be sent directly to the
Event Handler specified here.
Default display message: Message to display if not specified in the external
equipment. Default: BLANK
Default message priority: Priority if not specified in the external equipment.
Default: 7 (Normal)
Default beep code: Beep code if not specified in the external equipment.
Default: 2 beeps.
Default method for ack.: Select how the paging shall be acknowledged if not
specified by the external equipment.
Default: No Ack.
Default urgency: Urgency if not specified in the external equipment.
Default: Normal.
Transmission delay (x10 ms): How long to wait before transmission to external
equipment. Default: 30 milliseconds
Identical pagings treatment: How to handle identical pagings.
Default: Not accepted.
Running number
to ext equipment: If running number shall be sent or not. Default: No
Timeout mode: Determines when to start timeout mode i.e. remove
paging from queue. Default: after “Call Terminated“
call status.