Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
78
3 Click “Network” under Common in the menu on the Advanced Configuration page.
Figure 41. The Network page.
The following parameters can be set via the Advanced Configuration page. Some of these
parameters can also be set in the setup wizard.
• Require network connection - Controls if the module needs a connection to the network
to start up. This can be useful if you want configure the module before connecting it to a
network.
• DHCP - Controls whether static or dynamic IP address shall be assigned to this Elise
module. If DHCP is enabled, only the host name below is applicable.
• IP address - This parameter sets the IP address for Unite CM
• Default gateway - This parameter sets the IP address to a Gateway on the Local Area
Network (LAN).
• Subnet mask - This parameter sets the network mask that is to be used. If this
parameter is set to 0.0.0.0 it means that the Gateway never will be used.
• Host name
• Domain name - This parameter sets the desired domain name for Unite CM
• DNS Server - This parameter sets the IP address to a DNS if one exists. If no DNS Server is
present on the network, set this parameter to 0.0.0.0.
• WINS Server - This parameter sets the IP address to a Primary WINS Server if one exists.
If no WINS Server is present on the network, set this parameter to 0.0.0.0.
For additional information, see also Installation Guide, Elise3, TD 92679GB.
7.12 Setting License Number for Unite CM
It is possible to enter the license number via the Advanced Configuration page and the
Setup Wizard. The Unite CM must reboot after the new license number has been entered.
TIP: If you upgrading your Unite CM with a license to increase the number of messaging
users, you do not need to reboot the Unite CM. However, when changing the license via the
Setup Wizard, you must always reboot the Unite CM.
Figure 37.