Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
76
5 In the selected log page, enter settings.
6 Click “Activate”.
7.10 Time Settings
It is possible to select where to fetch the time from, such as a web browser or a time server.
1 Click “Configuration” on the start page.
2 Select Other > Advanced Configuration in the menu on the Configuration page.
3 Click “Settings” under Time, in the menu on the Advanced Configuration page.
Figure 39. The Time Settings page.
4 The following settings can be selected/changed. Some of these parameters can also
be set in the setup wizard:
5 Click “Activate”.
For additional information, see also Installation Guide, Elise3, TD 92679GB.
Figure 35.
Settings Description
Time source: Where to fetch the time; A-bus, web browser or NTP server
Time server address: IP address to NTP server
Fault log: Create fault log for time server faults
Time zone: Current time zone
Auto DST adjust: Automatic adjustment for daylight saving time
Date format: Which date format to use
Date separator: Which character to use to separate the date fields
Time Format: Which time format to use
Time push time: When to update all interfaces within the module