Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
69
7 Additional System Settings
7.1 Mail Server Address
To be able to send e-mails the address to the Mail server needs to be specified. The address
can also be set in the setup wizard.
1 Click “Configuration” on the start page.
2 Select Other > Advanced Configuration in the Configuration page.
3 Click “Mail Server” in the menu on the Advanced Configuration page.
4 Enter the IP address or hostname of the mail server and click “Activate”.
NOTE: The company mail server must be set up to allow relaying to be able to send
messages from the Ascom Messaging System as e-mails. (Contact your local IT
department).
7.2 UNS/User Server
It is possible to set which number plan (that is UNS) to be used in a system. By default, the
Unite CM is configured to use the local number plan, but it is possible to use another number
plan by forwarding all application requests to another UNS. Additionally, it is also possible to
forward to another UNS if the requested Call ID is not found in the local number plan (called
multi-site number plan).
NOTE: The Unite CM does not support forwarding to an ESS.
TIP: See also Function Description, Number Planning and Message Routing in Unite, TD
92254GB.
7.2.1 UNS Settings
1 Click “Configuration” on the start page.
2 Select Other > Advanced Configuration in the menu on the Configuration page.
3 Select "UNS" under Other on the Advanced Configuration page.
4 Select one of the following in the Operating mode drop-down list:
• Forwarding - Use if a another number plan is to be used instead of the local
number plan.
• Server - Use if only the local number plan is to be used (stand-alone), or if your
system having a multi-site number plan meaning that the UNS can forward a
request to another number plan if the Call ID is not found in the local number plan.