Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
68
If the device has not logged in again within the Online Status Report Time, the Status Log
Delay Time starts ticking. If the device does not log in again within that time a Status Report
is sent to the Fault Log.
1 Click “Configuration” on the start page.
2 Select Other Settings > Advanced Configuration on the Configuration page.
3 Under DECT Interface, click “Device Handling” in the menu on the Advanced
Configuration page.
4 Click the device type (that is, desktop charger or charging rack) to change settings
for.
5 Enter On-line Status Report Time in minutes.
6 To set the margin, enter Status Log Delay Time in minutes.
7 Click “Activate”.
6.4 On-line Status Report Time for Handsets in a Charging Unit
It is possible to set how often a device type placed in a charging unit must “log in” in order
to be considered on-line. This is called “On-line Status Report Time”.
If the device has not logged in again within the On-line Status Report Time, it will be
considered off-line.
1 Click “Configuration” on the start page.
2 Select Other Settings > Advanced Configuration on the Configuration page.
3 Under DECT Interface, click “Device Handling” in the menu on the Advanced
Configuration page.
4 Select device type to change settings for.
5 Enter On-line Status Report Time in minutes.
6 Click “Activate”.
6.5 Service Discovery
Service Discovery allows automatic detection of devices and services on a network without
prior configuration. Unite CM and the devices that shall belong to that Unite CM have to be
set to the same Domain ID.
1 Click “Configuration” on the start page.
2 Select Other Settings > Advanced Configuration on the Configuration page.
3 Under Other, click “Service Discovery” in the menu on the Advanced Configuration
page.
4 In the Domain ID field, enter the Service Discovery Domain ID.
5 Click “Activate”.