Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
67
6 Device Configuration
6.1 Device Management Setup
Device management is used for setting addresses to interfaces that the devices are
connected to. The specified interfaces will then inform the Device Manager about all logged
in devices.
1 Click “Configuration” on the start page.
2 Select Other Settings > Advanced Configuration, on the Configuration page.
3 Click “Device Management”. The Device Management page opens.
4 Enter Unite address to the interfaces that the devices are connected to.
5 Set whether communication with the license server shall be enabled or not.
6 Click “Activate”.
6.2 Device Handling Configuration
It is possible to set which device types that are allowed to log in to the module. This gives
you the possibility to for example only allow handsets to log in to one Device Manager and
chargers to log in to another Device Manager.
1 Click “Configuration” on the start page.
2 Select Other Settings > Advanced Configuration on the Configuration page.
3 Under DECT Interface, click “Device Handling” in the menu on the Advanced
Configuration page.
4 Select the device type to enable/disable login from.
5 Change Status to desired value.
6 Click “Activate”.
6.3 Online Status Report Time for Chargers
It is possible to set how often a device type must “log in” in order to be considered online.
This is called “Online Status Report Time”. To enable moving a charger without being logged
out, it is possible to set a “Status Log Delay Time”.