Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
55
4 Select “Module Fault List” in the menu to open the list.
5 Select level of seriousness in the drop-down list for the code(s) for which you want to
change level.
4.11.4 Fault Log
The fault log in Unite CM is a centralized log file and shows a complete log of the faults in
the system, on the assumption that other modules in the system are configured to send
their fault logs to Unite CM. Every time a fault message is generated in the system,
information about the fault is written to the log file. The maximum number of entries in the
log file is 1050. When the log file is full, the 50 oldest entries are removed.
1 Click “Configuration” on the start page.
2 Select Status > Fault Log in the left menu on the Configuration page.
The first 25 log entries are shown. To get the following 25 log entries, click the
“Next” link.
The following levels exist in the fault log:
• Information
• Individual reset
•All OK
• Critical error
•Error
• Warning
Figure 30. Example of a fault log in Unite CM.
Figure 29.