Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
53
The first time, or when new Event and Actions are going to be implemented, Event and
Actions has to be set up in a certain order.
1 Click “Action Assignment” on the start page.
Figure 28. Action Assignment page
TIP: during the configuration there are many GUI’s to log in to, and all of them prompt for
User ID and Password. During the configuration it is possible to keep the main GUI applet
open, that is, the first page that opens after you have logged in, in case you need to go back
to make changes. It is only possible to log in to one GUI at the time, that is, if you already
have one “Action Configuration” opened it is not possible to log in to another one.
4.10 System Supervision
Unite modules and other equipment in the system can be supervised, refer to 23 System
Supervision and Security on page 157.
4.11 Status
4.11.1 Active Faults
Active Faults page is where the last 100 received active persistent fault logs are listed. For
more information about the fault log, see 4.11.4 Fault Log on page 55.
1 Click “Configuration” on the start page.
2 Select Status > Active Faults in the menu on the Configuration page.
The following information is shown for each fault:
• Time when the fault occurred
• Level of the fault:
-Critical error
-Error
- Warning
• Description of the fault, as defined in the module
• Type of module
• IP address and host name of the module that generated the fault
By expanding the fault in the list, additional information about the fault is shown
containing:
Figure 27.