Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
50
If no configuration is done it will trigger on all incoming messages.
- Match Conditions: if there exists more than one trigger and they should differ from
each other the state and condition of the trigger can be changed.
It will activate the Extract and send data by default if nothing is done.
- Activations: conditions can be set on activation.
It will activate Extract and send data by default if nothing is done.
External Actions
This is where to create event element assignments.
• Open the folders, External Action > Extract and send data.
• Click Assignments, to create event element assignments.
• Define alarm type and location. There are four predefined examples:
•Alarm Type
• Alarm Type description
•Location
• Location description
Conversion tables
This is where to create and edit translation tables.
4.9.5 Alarm Management Client (AMC) Management
An external action on an event configured in Event Handler, can be to present information
on an AMC (Alarm Management Client).
Communication between Unite CM and AMC
The Unite CM controls all communication with the presentation clients (AMC). The Event
Handler has to be configured to send information to the client and also to confirm actions
taken in the AMC (acknowledge and reset of alarms).
When Event Handler sends a presentation block, Unite CM notifies the client that there are
new information to display, and when an acknowledge or reset request is received from the
client, it sends a presentation response block back to Event Handler. When Event Handler