Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
48
4.9.3 Event Handler
The Event Handler makes it possible to set up actions on incoming events. An event can be
mobile data, an alarm, activation of an input, etc. The Event Handler will then perform
different actions depending on the incoming event. Actions can be both internal, that is,
start other Actions after a delay, and external, i.e. send a message, start a siren, or present
information about the alarm in the Alarm Management Client (AMC).
In the Event Handler there are four different links, where events and triggers are set up for
Event Elements, an overview of the programming, to view Event Handler logs, and where to
administrate the data bases of the Event Handler.
More information about the configuration of the Event Handler is found in the document,
Programming Guide, Event Handler, TD 92329GB.
1 Click “Configuration” on the start page.
2 Select Alarm & Events > Advanced Handling in the menu on the Configuration page.
Figure 22. Links to the Event Handler
Programming Overview
The Overview shows an overview of the Event Handler programming, which can be a help
during programming.
View Logs
All changes in the configuration of the Event Handler are written to the log. It is also
possible to write information to the log, for example when a trigger is activated. For more
information about the log file and its content, see the chapter Event Log File in the
Programming Guide, Event Handler, TD 92329GB.
Administration
The database administration is used to synchronize the Event Elements that have been
created in the Event Assignment User Interface.
1 Click Administration, and go to Load Block database, located at the bottom of the
page.
2 Locate the database file and click “Load”, a dialogue window opens.
3 Click “Yes” to synchronize.
Figure 21.