Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
44
• Push to talk (PTT) Message
A PTT message makes it possible to set up a conference call. When a PTT message is
manually accepted by the user, the handset connects to the conference number and the
handsets involved in the conference are connected.
NOTE: Call IDs must be defined in Messaging Users. Refer to 4.1 Add Users to Unite CM on
page 19.
1 Select the time (in minutes) the receiving handset shall have the possibility to join
the conference, in the Time to Answer drop-down list.
2 Enter the number to the conference group in the Conference Number text field.
3 Do one of the following:
• Enter the Call IDs that shall receive the Push-to-talk message in the Call ID text
field. Each Call ID shall be separated with a comma.
• Click the symbol, to the right of the Call ID text field, if the message is to be
sent as a reply to the sender of the alarm or data.
4 Enter the message text in the Message Text field. By clicking the symbols to the right
of the text field you can add valuable information to the message, such as Call ID of
the sender, type of alarm and the location (location requires an additional license).
If an input is activated the description of the input can be added.
Figure 18. Available information for the alarm trigger
Figure 19. Available information for the input trigger
Figure 17.
Figure 18.