Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
43
2 Enter the message text in the Message Text field. By clicking the symbols to the right
of the text field, you can add valuable information to the message, such as Call ID of
the sender, type of alarm and the location (location requires an additional license).
If an input is activated the description of the input can be added.
Figure 15. Available information for the alarm trigger
Figure 16. Available information for the input trigger
Figure 17. Available information for the data trigger
3 Select number of beeps in the Beep Code drop-down list.
4 Select message priority in the Priority drop-down list.
5 Select the Request confirmation check box if it shall be possible for the user to accept
or reject the message. If no response is received an escalation action can take place,
refer to Select Escalation Action on page 45.
• Output Action
1 Select which output to activate in the Output drop-down list. Only outputs defined in
the I/O Setup are available. Refer to 4.7 Input/Output Setup on page 34.
2 Enter (in seconds) for how long the output shall be activated in the Duration text
field.
Figure 14.
Figure 15.
Figure 16.