Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
37
4.7.4 Input Activity Distribution
If the Unite CM’s input port(s) is activated, the Unite CM can trigger other services by
distributing the input activity to the services. The services in turn can then determine which
action to be performed depending on their settings.
The default services are SystemSurvey, EventHandler, OAJ, and BasicAlarmHandler. Note
that the default services might be license dependent. If your Unite CM does not have
license(s) for the service(s), remove the service(s) from the list to avoid fault messages in
the Unite CM’s fault log.
Figure 12. Default Input Activity Distribution List
1 Make sure that inputs have been defined according to 4.7.3 Define Inputs on page
36.
2 Click “Configuration” on the start page.
3 Select Other > Advanced Configuration. The Advanced Configuration page opens.
4 Click “Input Activity Distribution” under Other.
5 Enter the destination address(es) to the service(s) to be used. The address format is
IP address/service.