Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
36
4 Enter IP address of the module connected to the A-bus.
Normally loopback to localhost (that is, the IP-address is set to 127.0.0.1), but if the
A-bus is connected to another Unite module its IP address is set here.
5 Enter the Output Module's (whose output should be activated) “module address” on
the A-bus
6 Enter Output number.
7 Select Initial State and click “Save”.
4.7.3 Define Inputs
1 Click “Define new input”.
2 Enter a unique Input Name.
3 Enter IP address of the module connected to the A-bus.
Normally localhost (that is, the IP address is set to 127.0.0.1), but if the A-bus is
connected to another Unite module its IP address is set here.
4 Enter the Alarm Module’s “module address“ on the A-bus or select “Internal“
depending on if the input is connected via A-bus module or directly to Unite CM
hardware.
If you want to trigger on both opening and closing or using different “Activation
time“, you can define multiple inputs for the same physical input. This can for
example be used if you at a door (by using a microswitch) want an activation on both
opening and closing the door. Refer to Appendix F for other examples.
5 Enter Input number.
Note: If you have selected the internal check box in the previous step, enter the
number of the internal input (1 or 2).
6 Select Activation condition.
7 Enter Activation Time. By default, a notification will be sent immediately. If you enter
activation time, the input has to be active for the set time before a notification is
sent.
8 Click “Save”.