Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
35
Every time a new output or input is defined, an automatic ID is created. The ID is a running
number which can manually be changed into another number or a text if wanted. When an
output or input has been deleted, Unite CM will not remember that the previous ID number
is free to be used again. The numbering will just continue on the number after the last
created one.
4.7.1 Defining Inputs and Outputs
Before an input or output can be used in the configuration, it has to be defined with a name
and Module Address. The module address consists of IP address, and if Alarm Module and/or
Output Module are used, the module address on the A-bus.
Unite CM inputs
Unite CM hardware has two inputs that can be used. These inputs are predefined at delivery.
The states that can be detected are open and close.
Unite CM outputs
Unite CM hardware has two outputs of open-collector type that can be used in the Alarm
Handling and Fault Handling. These outputs are predefined at delivery. The initial state can
be set to high or low.
Alarm Module inputs
The number of inputs that can be used can be extended by using an Alarm Module (AM)
connected to the A-bus. The input on the AM is defined by a name, the IP address of the
Unite module connected to the A-bus, the AM’s module address
1
on the A-bus, and the
input number. The states that can be detected are open and close.
Output Module outputs
The number of outputs that can be used in Unite CM can be extended by using an Output
Module (OM) connected to the A-bus. The output on the OM is defined by a name, the IP
address of the Unite module connected to the A-bus, the OM’s module address
1
on the A-
bus and the output number. The initial state can be set to high or low.
For more information refer to the hardware Installation Guide, Elise3, TD 92679GB.
4.7.2 Define Output
1 Click Other > Input/Output
2 Click “Define new output”.
3 Enter a unique Output Name.
1.Every module that is connected to the A-bus has a two digit hexadecimal address that is set with a DIP switch.