Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
24
3 Click the “Advanced diversion” button on the User Setup page.
Add a diversion to a Not Reachable condition
1 As shown in the figure below, click the symbol in the grey field after the
destination address, in this case 1081-->DECT.
2 Enter settings and click "Save".
Add a diversion on the same level as the condition
1 Click the symbol after the primary destination, as shown in the figure below, in
this case 1080-->DECT.
2 Enter settings and click “Save”.